The Charlotte Area Transit System (CATS) Bus Operations Division (BOD) anticipates contracting for decals and graphics.  This would be a 5-year contract (3+1+1).

# 1847

The Charlotte Area Transit System (CATS) Bus Operations Division (BOD) anticipates contracting out for the inspection and service of fire extinguishers on up to 400 vehicles at the locations of 901 North Davidson and 3145 South Tryon.  Inspections will take place annually and will be serviced if necessary.  This is a 5 year contract (3+1+1).

# 1862

The Charlotte Area Transit System (CATS) Bus Operations Division (BOD) anticipates contracting for the supply of Detroit Bus Engine parts for the bus fleet.  This will be a 5-year contract (3+1+1).

# 1861

The Charlotte Area Transit System (CATS) Bus Operations division (BOD) anticipates contracting for preventative maintenance filters over a 5-year period (3+1+1).

# 1848

The Charlotte Area Transit System (CATS) Facilities Division anticipates contracting out the repair and replacement of windows and glass at various maintained facilities.

The contractor must be able to repair or replace all types of glass storefronts and doors and associated glass accessories or products, including but not limited to:
• Bus Shelters
• Store fronts/Aluminum Doors,
• Commercial Glass Doors,
• Frameless Glass Doors,
• Commercial Glass Walls,
• Commercial Mirror Walls,
• Interior Glass Systems,
• Back Painted Glass,
• Curtain Walls / Skylights,
• Specialty Glass (examples: acrylic, lexan, insulated, impact/bullet-resistant),
• Windows of all types, including single and double pane,
• Window screens, new and rescreened,
• Marker Boards,
• Glass trophy cases, show cases and glass shelves, and
• Typical associated glass accessories or products.

Services shall include, but not be limited to:
• Door repair, replacement or renovation,
• Window repair, replacement or renovation,
• Storefront repair, replacement or renovation,
• Water Intrusion Repair, and
• Emergency Repairs and Board-Up services.

PSR # 1845

The project will include construction up-fits at the North Yard Facility with intentions of utilizing the area as storage for CATS. The storage yard, also known as the North Yard Annex, will be a secured and monitored area with access control, security lighting, CCTV cameras, fencing, and power supply capable of providing climate control measures to material as needed.

PSR # 1840

Charlotte Area Transit System (CATS) anticipates contracting work to cover the necessary service to maintain four air compressors and four air dryers. The scope of work will, at a minimum, include the following: (1) performing basic services to all compressors and air dryers every three months, (2) performing basic services to all compressors and air dryers on an annual basis and (3) performing repairs as needed.

PSR 1803

This project is located in a parking lot behind the CLT Center located at 5601 Wilkinson Boulevard in Charlotte, NC.  The purpose of the project is to install new pipe to contain and drain runoff from the building to an existing storm drainage system at the rear of the parking lot.  The work involves installation of reinforced concrete pipe, storm drainage structures, asphalt surface, and re-striping the parking lot within the construction corridor.

Replace three (3) HVAC boilers at Environmental Services Facility. Current units are at end-of-life. Minimum specs are: natural gas-fed at 150CFH; input 1,500,000 BTU/HR; output 1,400,000 BTU/HR; forced-draft burner on 120V/single-phase power; support communication protocols for LON, BACnet, and IoT. In addition to materials provision, awarded vendor shall perform the following tasks: verify all pipe, conduit, and wiring spec in field prior to proposal; remove and dispose of existing units; disconnect and reconnect hot water lines; disconnect and reconnect all electrical wiring; disconnect and reconnect controls; assess and add/modify any unit drainage systems; run new stainless double wall flue pipes to exterior and terminate at roof; perform combustion analysis to assure proper operation; insulate all piping; perform startup and operation check after install; and any other tasks necessary to ensure optimal operation upon completion.