The Project consists of constructing water and/or sanitary sewer service installations at a single address (single applicant) or water and/or sanitary sewer service dismantlement at a single address (single applicant).
McAlpine Creek WWMF – Phase II Paving Improvements
The Project consists of constructing new and replacement asphalt concrete pavement in the areas indicated on Contract Documents along with storm water and chemical containment improvements.
Lee S. Dukes WTP HVAC Replacement
Charlotte Water will be replacing the Heating, Ventilation, and Air Conditioning (HVAC) unit for the administration building at Lee S. Dukes Water Treatment Plant (WTP). This project will be an in-kind replacement.
Pump and Motor Repair Service
This project will be to source a company to provide Charlotte Water with an electric pump and motor repair service. Some work will include repairs on explosion-proof (“EX”)-rated motors designed for use in hazardous areas and motor drive units. Work shall be performed to achieve a consistent, high-quality repair and/or reconditioning of a failed motor, and shall restore the motor to as-manufactured condition with the least service interruption feasibly possible. Service shall also include repairs to close-coupled pumps, such as submersible units.
this opportunity was archived earlier
Irwin Creek Wastewater Treatment Plant Cleaning of Process Tanks
Charlotte Water is seeking a company to perform all labor, materials, chemicals, supplies, equipment, transportation, and other incidentals required for the removal, mechanical dewatering, filtrate management, transportation, and disposal of all materials from the Irwin Creek wastewater treatment plant (WWTP) process tanks including six digester tanks and the digested sludge storage tank.
- Approximately 1,600,000 gallons of sludge
- Approximate/Average concentration of 3.0%
- Approximate dewatered sludge concentration of 17.2%
- Calculated 1,200 approximate wet tons of dewatered sludge/cake disposal
- Solids capture efficiency of 95% or higher
- Maximum wash water rate of 60 GPM (for the entire unit, not per belt wash station)
Delinquency Letter Printing and Mailing Services
Charlotte Water is soliciting proposals for a company to provide printing and mailing services for delinquency letters.
Catawba Pump Station Rehabilitation Project
The Project site is the Catawba Raw Water Pump Station located on Mountain Island Lake, owned & operated by Charlotte Water. The site address is 12548 Pump Station Rd, Charlotte, NC 28216. The work under this project will be primarily in Cells #2 & 3. The electrical work consists of changing the Cell #3 voltage from 2300V to 4160V, including new switchgear, synchronous motor, conduit, cable, etc. as well as re-winding an existing electric pump motor. The civil/mechanical work consists of rebuilding/replacing screens, rehabbing cone valves, and installing a new flow meter vault. The structural work consists of new electrical vault, drywall electrical room, masonry, doors, windows, louvers, and fans. This project also includes upgrades to the fire alarm system for the entire Catawba Pump Station facility.
Fire Extinguisher Maintenance, Training, and Inspection Services – Cancelled
This project will be to obtain a contract with a company that will provide full comprehensive inspection, testing, maintenance, training, and repair services for fire extinguishers for Charlotte Water facilities.
Water Treatment Valve Rehabilitation Services
Charlotte Water will be seeking a company to inspect Charlotte Water (Water Treatment division) valves for rehabilitation needs in order to maintain their operational status and minimize downtime. Valves will be disconnected and reconnected by Charlotte Water.