Replace three (3) HVAC boilers at Environmental Services Facility. Current units are at end-of-life. Minimum specs are: natural gas-fed at 150CFH; input 1,500,000 BTU/HR; output 1,400,000 BTU/HR; forced-draft burner on 120V/single-phase power; support communication protocols for LON, BACnet, and IoT. In addition to materials provision, awarded vendor shall perform the following tasks: verify all pipe, conduit, and wiring spec in field prior to proposal; remove and dispose of existing units; disconnect and reconnect hot water lines; disconnect and reconnect all electrical wiring; disconnect and reconnect controls; assess and add/modify any unit drainage systems; run new stainless double wall flue pipes to exterior and terminate at roof; perform combustion analysis to assure proper operation; insulate all piping; perform startup and operation check after install; and any other tasks necessary to ensure optimal operation upon completion.

This contract is for the continuous installation of large water and sewer services, as needed, for commercial or residential purposes with a diameter one and a half inches or larger. Customers apply for quotes for service connection and pay the applicable fees to get into the construction queue. This contract will help meet the demand for these kinds of service connections for the next two years.

This project includes safety improvements at 8 sites, focusing on low-cost, high-impact measures such as pedestrian crossings, accessible pedestrian signals (APS), leading pedestrian intervals (LPIs), and priority projects from a Safe Routes to School study.

This project will address the non-conforming, physical ADA barriers to the greatest extent feasible and where applicable under code provisions. Phase 2 includes the Charlotte-Mecklenburg Government Center and adjacent Parking Garage.  Scope areas include Exterior Plaza, Entrance Lobby, 2nd Floor Mezzanine and the 15-story Highrise. Specific scope includes, but is not limited to, Partitions, Doors and Door Hardware, Ramps, Millwork, Restrooms, Controlled Access, Obstructions, Plaza Deck and Accessible Routes. The project delivery method is Construction Manager at Risk (CMAR).  The CMAR will commence with CBI outreach ~3rd qtr 2025 and trade partner pre-qualification ~4th qtr 2025.

This contract will provide installation services for small-diameter water and sewer service connections within the Charlotte Water service area. It will replace the existing FY24 Small Service Contract #1. The work will help meet growing service demands and maintain system reliability.

This contract will provide installation services for small-diameter water and sewer service connections within the Charlotte Water service area. It will replace the existing FY24 Small Service Contract #2. The project ensures continued expansion and maintenance of service connections across the region.